Tektronix CPS250 Manuel d'utilisateur télécharger pdf (Page 12)

Getting Started

CPS250 User Manual

Preparing the Power Supply for Use

Check the following items prior to operating the CPS250 Triple

Output Power Supply for the first time (see Figure 1 for locations of

items 1 through 3):

1 2

Figure 1: Line Voltage Selectors, Power Input, and Fuse Locations

CAUTION. To prevent damage to the instrument, set the line voltage

selectors to the proper voltage setting and install the correct line

voltage fuse before operating the equipment.

1. Set the line voltage selectors to the input line voltage. These

selectors connect internal wiring for various line voltages. This

product is intended to operate from a power source that does not

supply more than 250 V

RMS

between the supply conductors or

between either supply conductor and ground. For line voltage

ranges, refer to Appendix A: Specifications on page 17.

WARNING. To prevent electrical shock, unplug the power cord and

disconnect the test leads from the circujit before checking or

replacing the fuse.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Pas de commentaire

Tektronix CPS250 Manuel d'utilisateur Page 12