Tektronix MTM400 Manuel d'utilisateur télécharger pdf (Page 127)

Stream View

MTM400 MPEG Transport Stream Monitor User Manual 3-79

Virtual Channel Table Mode

(ATSC only) A drop-down list from which the Virtual Channel

Table Mode can be selected. The options available are shown

below:

Interface A drop-down list from which the interface to be used for the

stream is selected. The interfaces available, such as SMPTE,

ASI and QPSK (L-Band), will depend upon the RTM device.

Config… Opens the configuration dialog for the selected interface.

(See page 3-107.)

Stream Name Allows you to assign a name to the stream. The name set will

appear wherever the stream name is displayed, for example, in

the title bar of all screens.

Enter the required name and select the Set button.

If you do not set a name, the default name, Stream, is used.

IIP PID (ISDB only) Allows you to specify the packet number of the

ISDB-T Information Packet.

The IIP PID value is predefined; to change it, enter the required

value and select the Set button.

Enable Holdoff and Test Holdoff Delay

(ISDB only) Enables and sets how long after a PAT/PMT SI

version change all tests are disabled.

SI Parameter Descriptor Processing

(ISDB Only) The MTM400 can process SI repetition rates tests

against user definable parameters, or by taking dynamic test

limits from the broadcast SI when available.

Template Checking*

When enabled, applies the current template to the stream.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 196 197

Pas de commentaire

Tektronix MTM400 Manuel d'utilisateur Page 127