Tektronix AD007 Manuel d'utilisateur télécharger pdf (Page 28)

Getting Started

AD007 User Manual

Setup Procedure 1 - Complete Factory Reset, Set DHCP On

If the following conditions are true, you may want to completely

reset the ada pter to the factory defaul t settings.

H The adapter has been used before and is configured with

unknown settings.

H DHCP is off and the adapt er does not request an IP address from

the network.

H You a r e not able to access the web pages of the adapter because

the adapter is configured with unknown settings.

H YouwanttoturnDHCPon.

To reset to the factory default settings (and turn DHCP on), do these

steps:

1. Power the AD007 a dapter off.

2. Use a small tool or end of a paper clip to push in and hold the

reset button.

3. Power on the AD007 adapt er and hold the reset button in until all

status indicators go to a steady amber (approximately 30 se-

conds), then release the button. The AD007 adapter automatically

reboots with the factory defaults.

4. For a complete list of the factory default settings, see Table 6 on

page 52.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

Pas de commentaire

Tektronix AD007 Manuel d'utilisateur Page 28