Tektronix j17 Manuel d'utilisateur Page 62

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 106
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 61
Maintenance
Maintenance
6-6
3. Other problems are typically due to the A1 board.
If a power supply problem is suspected, perform
the procedure in     on
page 6-6 to verify that the power supply, and
not the battery, is at fault.
The A1 Board
Most functions of the J17 are located on the
A1 board.     on page 6-6
will allow you to determine whether there is a power
supply problem.
The A2 Display Board
The A2 Display board is probably at fault if:
H segments of the display are missing
H the backlight does not operate
To check the display, power on the J17 without a
sensorĆhead attached, and note whether all segĆ
ments of the display are activated.
If the entire display is inactive, or if the backlight does
not operate, proceed to    
to rule out a problem with the power supply.
Checking the Power Supply
To check the power supply, you will need:
H
3
/
32
Ăinch hex wrench
H Posidrivscrewdriver
H a DC voltmeter
(for voltages in the range 0 to 15 V)
H NineĆvolt, IEC 6LR61Ćtype alkaline battery
Maintenance
Maintenance
6-6
3. Other problems are typically due to the A1 board.
If a power supply problem is suspected, perform
the procedure in     on
page 6-6 to verify that the power supply, and
not the battery, is at fault.
The A1 Board
Most functions of the J17 are located on the
A1 board.     on page 6-6
will allow you to determine whether there is a power
supply problem.
The A2 Display Board
The A2 Display board is probably at fault if:
H segments of the display are missing
H the backlight does not operate
To check the display, power on the J17 without a
sensorĆhead attached, and note whether all segĆ
ments of the display are activated.
If the entire display is inactive, or if the backlight does
not operate, proceed to    
to rule out a problem with the power supply.
Checking the Power Supply
To check the power supply, you will need:
H
3
/
32
Ăinch hex wrench
H Posidrivscrewdriver
H a DC voltmeter
(for voltages in the range 0 to 15 V)
H NineĆvolt, IEC 6LR61Ćtype alkaline battery
Vue de la page 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 105 106

Commentaires sur ces manuels

Pas de commentaire