Tektronix Thermometer P6249 Manuel d'utilisateur télécharger pdf (Page 65)

P6249 4 GHz 5X Active Probe Instruction Manual

Maintenance

This section describes the maintenance and repair procedures for the

P6249.

Replacing TEKPROBE Interface Pins

TEKPROBE interface pins can stick and fail to make contact after

time. Periodically check to see that each of the interface pins move

freely and fully extends out of the interface. If any pin fails to move

freely and fully extend, replace the pin.

To remove a TEKPROBE interface pin, firmly grasp the pointed tip

with pliers and pull the pin out of the connector. See Figure 18.

No tools are required to install a replacement pin. Insert a new pin

into the connector socket as far as possible using finger pressure. If

necessary, seat the pin into the connector by pressing the tip gently

but firmly against a hard surface, such as a wood block or table top.

Figure 18: Replacing TEKPROBE interface pins

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 81 82

Pas de commentaire

Tektronix Thermometer P6249 Manuel d'utilisateur Page 65