Tektronix THS710A Manuel d'utilisateur télécharger pdf (Page 103)

Maintenance

THS710A, THS720A, THS730A & THS720P Service Manual

6–21

Install foam pads

Install foam pad

Install I/O port

hole plug

Install DC power

hole plug

Figure 6–12: Foam pad and hole plug locations on the back cover

c. Place the back cover on a soft surface with the BNC connector openings

facing away from you.

d. Dress the battery wires to the left side of the back cover to provide

clearance for the chassis.

e. While inserting the BNC connectors into their openings, lower the

chassis into the back cover.

f. Reconnect the battery wire connector and press it onto its retaining pins.

Check that the polarity of the connector is correct. Dress the wires into

the channel on the chassis as shown in Figure 6–13.

3. Install the switch mat and front cover using the procedure on page 6–12.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 141 142

Pas de commentaire

Tektronix THS710A Manuel d'utilisateur Page 103