Tektronix K1297-G20 Manuel d'utilisateur télécharger pdf (Page 70)

Getting Started

K1297-G20 Monitor User Manual

Ethernet Connection

If you want to operate the protocol tester in a local Ethernet network, you

can use the built-in network adapter of the protocol tester. To establish an

Ethernet connection, connect your Ethernet cable to the 10BaseT /

100BaseTX connector of the K1297 PC board.

The properties for the default connection can you see in the Local Area

Connection Properties dialog box. To open this dialog box, proceed as follows:

1. Select Start / Control Panel / Network Connections. The Network

Connections dialog box opens.

2. Double-click an active Local Area Connection. A Status dialog box for

this connection opens. By pressing the Properties button you open the

Local Area Connection Properties dialog box.

Figure 1: Local Area Connection Properties, Generals tab

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 197 198

Pas de commentaire

Tektronix K1297-G20 Manuel d'utilisateur Page 70