Tektronix 200 Series Manuel d'utilisateur télécharger pdf (Page 107)

RARP and BOOTP

User Manual

B-7

To start the bootpd daemon without rebooting the system, type:

/etc/bootpd -s &

BOOTP running only on request

If the bootpd command line does not exist in your /etc/inetd.conf

Þle, you need to add it. To verify that the bootpd startup

command is in the Þle, type:

grep bootpd /etc/inetd.conf

If the bootpd startup command is in the Þle, the following line is

displayed:

bootps dgram udp wait root /etc/bootpd bootpd

Verify that bootpd resides where it is speciÞed in /etc/inetd.conf.

For the preceding examples, bootpd would be located in /etc. If

there is a mismatch between the actual location and the speciÞed

location, either move the bootpd binary or change the

/etc/inetd.conf Þle.

The port numbers for BOOTP listening and replying must be set in

the /etc/services Þle. If they are not set, edit the Þle and add them.

To verify that the ports are set in the Þle, type:

grep bootp /etc/services

If the ports are set in the Þle, the following line is displayed:

bootps 67/udp

bootpc 68/udp

1 2 ... 102 103 104 105 106 107 108 109 110 111 112

Pas de commentaire

Tektronix 200 Series Manuel d'utilisateur Page 107