Tektronix 784A Manuel d'utilisateur télécharger pdf (Page 211)

Removal and Installation Procedures

TDS 684A, TDS 744A, & TDS 784A Service Manual

6–27

c. Repeat procedure to remove the remaining cap as needed; push the

cap(s) back on to reinstall.

5. Remove the flip stand: Grasp the flip stand by both sides near where it joins

each flip stand foot. Now compress the flip stand until the flip stand ends

clear the flip stand feet to complete the removal.

6. Remove the flip stand foot (or feet):

a. Do Rear Cover and Cabinet procedure (page 6–18) to gain access to

inside of the cabinet.

b. Working from inside the cabinet, push the two retainers to release the

flip stand foot you wish to remove and lift it away from the outside of

the cabinet.

c. Repeat procedure to remove as many of the remaining feet as needed;

insert the two retainers back in their slots in the cabinet and snap into

place any flip stand foot removed.

7. Reinstallation: If any flip stand feet were removed, reinstall as directed in

step 6c; then see Rear Cover and Cabinet procedure (page 6–18) to reinstall

the rear cover and cabinet. Do in reverse order steps 3 and 5, reversing each

step, to reinstall the flip stand, then the handle caps (if removed), then the

handle.

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 293 294

Pas de commentaire

Tektronix 784A Manuel d'utilisateur Page 211