Tektronix Phaser 600 Manuel d'utilisateur télécharger pdf (Page 533)

SETTING POSTSCRIPT AND HP-GL JOB AND WAIT TIMEOUTS

Setting PostScript and HP-GL job

and wait timeouts

The HP-GL job timeout is the same as the PostScript job timeout.

The following timeouts can be set in the printer:

■ The wait timeout is the amount of time in seconds that the printer waits for

data to come from the computer during a job. If the data stream pauses

for longer than the speciﬁed number of seconds, a timeout error is

generated and the job is canceled.

■ The job timeout is the amount of time any single job may be active before

it must print.

■ In PostScript mode, if the value is exceeded, a timeout error is

■ In HP-GL mode, if the timeout value is too small, an image may be split

across two pages; if the value is too large, multiple-page prints may be

combined on one page.

Pas de commentaire

Tektronix Phaser 600 Manuel d'utilisateur Page 533