Tektronix TDS500C Manuel d'utilisateur télécharger pdf (Page 30)

Brief Procedures

1–14

TDS 500C, TDS 600B & TDS 700C Performance Verification and Specifications

H Turn the general purpose knob to select the file to save. Choose

 (or fd0:, the floppy disk drive, or hd0:, the optional

hard disk drive). With this choice, you will save a file starting with

, then containing 5-numbers, and a  extension. For example,

the first time you run this on a blank, formatted disk or on the

Example Programs Disk, the oscilloscope will assign the name

 to your file. If you ran the procedure again, the

oscilloscope would increment the name and call the file

.

f. To test the optional hard disk drive, use the general purpose knob to

select the file to save. Then choose the hard disk drive (hd0:). Save the

file as in step e.

H Press the side-menu button Save To Selected File.

2. Verify the file system works:

H Press the main-menu button Recall Factory Setup and the side-menu

button OK Confirm Factory Init to restore the 500 s time base and

the five cycle waveform.

H Press the main-menu button Recall Saved Setup; then press the

side-menu button From File.

H Turn the general purpose knob to select the file to recall. For example, if

you followed the instructions previously and saved the file to either the

floppy disk drive (fd0:), or the optional hard disk drive (hd0:), you had

the oscilloscope assign the name TEK00000.SET to your file.

H Press the side-menu button Recall From Selected File.

H Verify that digitizing oscilloscope retrieved the saved setup from the

disk. Do this by noticing the horizontal SCALE for the M (main) time

base is again 200 s and the waveform shows only two cycles just as it

was when you saved the setup.

3. Remove the test hookup:

H Disconnect the probe from the channel input and the probe-compensa-

tion terminals.

H Remove the floppy disk from the floppy disk drive.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 147 148

Pas de commentaire

Tektronix TDS500C Manuel d'utilisateur Page 30