Tektronix P H A S E R Phaser 840 Manuel d'utilisateur télécharger pdf (Page 22)

Connecting Your Printer to a Network

PhaserShare Networking

PhaserShare Series B LocalTalk card

When a PhaserShare Series B card is purchased initially with the printer, it is

installed at the factory. When a PhaserShare Series B card is purchased later as

an upgrade kit, follow the installation instructions that are shipped with the

card. Both the LocalTalk connection on the card and the Ethernet connector on

the printer’s rear panel are simultaneously active.

LocalTalk connection

LocalTalk is sometimes referred to as AppleTalk. LocalTalk refers to the

physical connection; AppleTalk is the protocol.

You can make LocalTalk connections between the printer and a single computer

or a LocalTalk network. If your LocalTalk installation is complex, or if you need

assistance, contact your network system administrator.

Connect your printer to a LocalTalk network before you turn on the printer.

LocalTalk card connections and indicators

TX indicator (yellow); blinks while the interface is transmitting.

RX indicator (green); blinks while the interface is receiving.

LocalTalk connector; 8-pin, circular DIN.

Both indicators ﬂashing together indicates a fatal software error. Turn the

printer off, then on again; if the problem persists, replace the card.

9789-07

LocalTalk®

PhaserShare

Series B

LocalTalk Card

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Pas de commentaire

Tektronix P H A S E R Phaser 840 Manuel d'utilisateur Page 22