Tektronix P H A S E R Phaser 840 Manuel d'utilisateur télécharger pdf (Page 35)

TCP/IP Configuration (UNIX)

Setup Guide

Set up spool directories. After you have edited the /etc/hosts and

/etc/printcap ﬁles, create and set permissions for the spool directory you

speciﬁed. For example:

cd /usr/spool/lpd

mkdir colorprinter

chown daemon colorprinter

chgrp daemon colorprinter

chmod 770 colorprinter

Refer to your UNIX documentation for the correct command syntax for

your workstation.

Printer conﬁguration

There are two steps to printer conﬁguration:

Set the printer’s IP address and other addressing information. The

Phaser 840 printer supports the use of IP host name as well as an IP

address. See Chapter 8, “Setting the Printer’s IP Addressing

Parameters” for more information.

Set the printer’s other TCP/IP parameters (optional):

■ Set host access and control-character ﬁltering for each port.

■ Receiving printer status (Syslog, SNMP, or email notiﬁcation).

For information on setting these TCP/IP parameters, see the

PhaserShare Networking Manual on the printer’s CD-ROM.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Pas de commentaire

Tektronix P H A S E R Phaser 840 Manuel d'utilisateur Page 35