Tektronix P H A S E R Phaser 840 Manuel d'utilisateur télécharger pdf (Page 23)

Connecting Your Printer to a Network

Setup Guide

LocalTalk connectors, cables, and terminators

LocalTalk connectors and cables are available through your local reseller.

Depending on the type of LocalTalk cables you use and your network

conﬁguration, you might need to use terminators at certain points in the

installation. Refer to the documentation for your LocalTalk connectors and

cables for details.

Connecting to a single computer

To avoid damaging the network interface, turn off the printer before making any

LocalTalk connections.

Connect the short cable of a LocalTalk connector to the PhaserShare

LocalTalk port.

Connect the short cable of another LocalTalk connector to your

computer’s LocalTalk port.

Connect a LocalTalk cable from the LocalTalk connector that you have

just attached to your computer to the printer’s LocalTalk connector.

Depending on the type of LocalTalk connectors you use and your network

conﬁguration, you might need to use external terminators. Refer to the

documentation for your LocalTalk connectors and cables for details.

For conﬁguration details, see Chapter 3, “EtherTalk, LocalTalk, and TokenTalk

Conﬁguration”.

9789-08

LocalTalk®

PhaserShare

Series B LocalTalk Card

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Pas de commentaire

Tektronix P H A S E R Phaser 840 Manuel d'utilisateur Page 23