Tektronix DPO4000 Manuel d'utilisateur Page 391

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 585
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 390
Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A{:TRANsition|:R ISEFall}:SOUrce?
Arguments
CH1–CH4 species one input channel as the edge source.
MATH species the math waveform as the search source.
SEARCH:SEARCH<x>:TRIGger:A{:TRANsition|:RISEFall}:WHEn
Sets or returns the condition setting for an transition trigger search to determine
where to place a mark. <x> is the search number.
Grou
p
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A {:TRANsition|:RISEFall}:WHEn
{SLOWer|FASTer|EQual|UNEQu al}
SEARCH:SEARCH<x>:TRIGger:A {:TRANsition|:RISEFall}:WHEn?
Arguments
FASTer sets the trigger to occur when the transitioning signal is faster than the set
volts/second rate.
SLOWer sets t
he trigger to occur when the transitioning signal is slower than
the set volts/second rate.
EQual sets the trigger to occur when the transitioning signal is equal to the set
volts/second rate within a ±5% tolerance.
UNEQual sets the trigger to occur when the transitioning signal is not equal to
the set volts/second rate ±5%.
SEARCH:SEARCH<x>:TRIGger:A:TYPe
Sets or returns the trigger type setting for a search to determine where to place a
mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TYPe
{EDGe|SETHold|PULSEWidth|R UNt|TRANsition|LOGIc|BUS (with the
appropriate application module installed)}
SEARCH:SEARCH<x>:TRIGger:A :TYPe?
Arguments
RUNt triggers when a pulse crosses the rst preset voltage threshold but does not
cross the second pre set threshold before recrossing the rst. The thresholds are
MSO4000 and DPO4000 Series Programmer Manual 2-381
Vue de la page 390
1 2 ... 386 387 388 389 390 391 392 393 394 395 396 ... 584 585

Commentaires sur ces manuels

Pas de commentaire